QUESTION 169
What two things will a router do when running a distance vector routing protocol? (Choose two)
A. Send periodic updates regardless of topology changes.
B. Send entire routing table to all routers in the routing domain.
C. Use the shortest-path algorithm to the determine best path.
D. Update the routing table based on updates from their neighbors.
E. Maintain the topology of the entire network in its database.
Correct Answer: AD
QUESTION 170
What is the purpose of the inverse ARP?
A. to map a known DLCI to an IP address
B. to map a known IP address to a MAC address
C. to map known SPID to a MACaddress
D. to map a known DLCI to a MAC address
E. to map a known IP address to a SPID.
F. to map a known MAC address to an IP address
Correct Answer: A
QUESTION 172
Refer to the exhibit. For what two reasons has the router loaded its IOS image from the location that is shown?
(Choose two)
Router1> show version
Cisco Internetwork Operating System Software
IOS ™ 7200 Software (C7200-J-M), Experimental Version 11.3tl997091S:1647S2)
[hampton-nitro-baseline 249]
Copyright (c) 1986-1997 by cisco Systems, Inc.
Compiled Wed 08-0ct-97 06:39 by hampton
Image text-base: 0×60008900, data-base: 0x60B98000
ROM: System Bootstrap, Version 11.1(11855) [beta 2], INTERIM SOFTWARE
BOOTPLASH: 7200 Software (C7200-BOOT-M), Version 11.1(472), RELEASE SOFTWARE (fcl)
Router1 uptime is 23 hours, 33 minutes
System restarted by abort at PC 0x6022322C at 10:50:SS PDT Tue Oct 21 1997
System image file is “tftp://112.16.1.129/hampton/nitro/c7200-j-mz”
cisco 7206 (NPE150) processor with 57344K/8192K bytes of memory.
Configuration register is 0×2102
A. Router1 has specific boot system command that instruct it to load IOS from TFTP server.
B. Router1 is acting as a TFTP server for other routers.
C. Router1 cannot locate a valid IOS image in flash memory.
D. Router1 defaulted to ROMMON mode and loaded the IOS image from a TFTP server.
E. Cisco routers will first attempt to load a image from TFTP for management purposes.
Correct Answer: AC
QUESTION 174
How is an EUI-64 format interface ID created from a 48-bit MAC address?
A. by appending 0xFF to the MAC address.
B. by prefixing the MAC address with 0xFFEE.
C. by prefixing the MAC address with 0xFF and appending 0xFF to it.
D. by inserting 0xFFFE between the upper three bytes and the lower three bytes of the MAC address
E. by prefixing the MAC address with 0xF and inserting 0xF after each of its first three bytes.
Correct Answer: D
QUESTION 176
Refer to the exhibit. A network technician is asked to design a small network with redundancy. The exhibit
represents this design, with all hosts configured in the same VLAN. What conclusions can be made about this
design?
A. The design will function as intended
B. Spanning-tree will need to be used.
C. The router will not accept the addressing scheme.
D. The connection between switches should be a trunk.
E. The router interfaces must be encapsulated with the 802.1Q protocol.
Correct Answer: C
QUESTION 178
Which command displays CPU utilization?
A. show protocols
B. show process
C. show system
D. show version
Correct Answer: B
QUESTION 181
Which command reveals the last method used to powercycle a router?
A. show reload
B. show boot
C. show running-config
D. show version
Correct Answer: D
QUESTION 182
When you are troubleshooting an ACL issue on a router, which command would you use to verify which
interfaces are affected by the ACL?
A. show ip access-lists
B. show access-lists
C. show interface
D. show ip interface
E. list ip interface
Correct Answer: D