ICMP Echo requests from host A are not reaching the intended destination on host B. What is the problem

Question 5:
ICMP Echo requests from host A are not reaching the intended destination on host B. What is the problem?

A. The ICMP payload is malformed.
B. The ICMP Identifier (BE) is invalid.
C. The negotiation of the connection failed.
D. The packet is dropped at the next hop.
E. The link is congested.

Correct Answer: D

QUESTION 6
Refer to the exhibit.

Which statement is true?

A. It is impossible for the destination interface to equal the source interface.
B. NAT on a stick is performed on interface Et0/0.
C. There is a potential routing loop.
D. This output represents a UDP flow or a TCP flow.
Correct Answer: C

QUESTION 13
Refer to the exhibit.
While troubleshooting high CPU utilization of a Cisco Catalyst 4500 Series Switch, you notice the error
message that is shown in the exhibit in the log file. What can be the cause of this issue, and how can it be
prevented?

A. The hardware routing table is full. Redistribute from BGP into IGP.
B. The software routing table is full. Redistribute from BGP into IGP.
C. The hardware routing table is full. Reduce the number of routes in the routing table.
D. The software routing table is full. Reduce the number of routes in the routing table.
Correct Answer: C

QUESTION 22
Refer to the exhibit.

What is the meaning of the asterisk (*) in the output?

A. PIM neighbor 10.1.5.6 is the RPF neighbor for the group 232.1.1.1 for the shared tree.
B. PIM neighbor 10.1.5.6 is the one that is seen as the RPF neighbor when performing the command show ip
rpf 10.1.4.7.
C. PIM neighbor 10.1.5.6 is the winner of an assert mechanism.
D. The RPF neighbor 10.1.5.6 is invalid.

Correct Answer: C

QUESTION 27
Refer to the exhibit.

Routers R1, R2, and R3 are configured as shown, and traffic from R2 fails to reach 172.29.168.3.
Which action can you take to correct the problem?

A. Correct the static route on R1.
B. Correct the default route on R2.
C. Edit the EIGRP configuration of R3 to enable auto-summary.
D. Correct the network statement for 172.29.168.3 on R3.
Correct Answer: A