Showing 10 of 25 Blog Posts
In Static routing the network administrator hand type the path for routing. As Router>enable Router# conf terminal Roter(config)# int e0 Router(config_if)# ip add 192.168.10.10 255.255.255.0 Router(config_ig)#...
By default only hosts are member of the same VLAN can communicate. To change this and allow inter-vlan communication, we need a layer 3 switch or router....
Direct Access through Console port Access through LAN by Telnet SSH (source socket shell)application Step1. Direct access through console port After physical connectivity Open hyper terminal application...
Ans : Vlan create on Switches not router :p All the following information is taken from the data sheets for these devices, on the Cisco website. The...
Question 1 Refer to the exhibit. The following commands are executed on interface fa0/1 of 2950Switch. 2950Switch(config-if)#switchport port-security 2950Switch(config-if)#switchport port-security mac-address sticky 2950Switch(config-if)#switchport port-security maximum 1 The...
Here you will find answers to WAN Questions Question 1 Users have been complaining that their Frame Relay connection to the corporate site is very slow. The...
There are only three main Differences between Rip1 and Rip2 RIP version 1: In Rip Version 1 use Broadcast and it is Class Full Routing protocol. No Authenticaion Required in Rip...
Have you ever wondered what a Virtual LAN (or VLAN) is or been unclear as to why you would want one? If so, I have been in...
Here you will find answers to EIGRP Questions Question 2: As a Cisco technician, you need to know EIGRP protocol very well. Which of the following is...
